Things to note when choosing wrought iron gates:

1. How to control the quality of wrought iron gates? The internal ornaments are welded from wire rods of different specifications (thin flat materials, thin square tubes). The diameter and strength of the wire rods directly affect the quality of the wrought iron ornaments. In terms of selection, you should choose high-quality finished wrought iron gates produced by regular manufacturers; secondly, the welding and forging masters of wrought iron gates have been handmade for several years. This aspect mainly depends on the skilled techniques and operating capabilities between technicians and good production machinery. Usually, every welding or weaving point of the wrought iron gate can be well connected. Products made by informal small stores and workshops are usually very thin and textureless, and usually the quality and maintenance are difficult to guarantee.

2. How to control the quality of the internal ornaments and frames of wrought iron gates in the forged steel production process commonly used by regular enterprises. Such wrought iron guardrails are much stronger than ordinary steel pipe guardrails. Moreover, the forged steel wrought iron guardrails look very layered and three-dimensional, and are noble.

Preparation for iron gate construction:

1. When the iron gate is ready, it must have a factory certificate and test report, and its specifications, models, and sizes must meet the design requirements. Put the window code in a safe place, pad the wood, and cover it. Avoid making mistakes, otherwise it will be difficult to cooperate with customers later.

2. Draw the position line of the iron gate, and determine the installation elevation based on the 50cm horizontal line.

3. Unpacking, inspection and transportation of the iron gate are more important, because customers do not want the iron gate to be damaged during transportation. Check the model and the quality of the iron art according to the requirements of the drawings. If you find that there are missing edges and corners, warping, deviations exceed the standard, serious damage scratches, and large color differences in appearance, you should negotiate carefully, and after repair and identification, you can install it. In addition, check whether the iron gate has a protective film. If there is a defect, it should be repaired and installed. Prepare the scaffolding for installation and take safety precautions. Because safe production is the principle we have been pursuing.

Key points for iron gate construction: The iron gate installation adopts the installation method of pre-reserving the hole and then plugging it. The horizontal position of the iron gate hole should be based on the 50cm line of the wall. Go up and measure the elevation of the window skin, and use the line to find the straightness. To ensure that the windows on each floor are connected up and down, use the theodolite to mark the straight lines on both sides on the wall. Leave a gap of 10-15mm on each side between the plastic steel frame and the wall.