Next, the manufacturer will introduce the installation steps for you.

Iron staircase installation Step 1:

In the installation to find the right position, to have a fixed height and line installation handrail, arc Angle and other positions, to be familiar with the longitudinal and center line of the pop-up handrail. Then according to its position, draw the line segment, elbow, fold and other positions. Elbow according to the top slope of the handrail or railing configuration, with a good starting elbow, general handrail, can use handrail material cutting and elbow, cutting Angle and weld bonding, in the block cutting and section, at least consider four screws and bracket fixed. When making handrail joints with a cross section of more than 70 mm, in addition to bonding, a mortise or riveted joint should be installed underneath.

Wrought iron stair installation Step 2:

When making the entire bend, a template must be made, inspected with a field mark, and then the elbow material is marked again according to the template to make the prototype wool material. Pre-assembled according to the marked position, bonded to the end of the longitudinal straight handrail, slotted under the elbow, and closely combined with the flat steel or fixed parts of the railing.

Iron staircase installation Step 3:

In the connection of the pre-assembled prefabricated escalator must be pre-installed, the pre-assembled wooden escalator must be developed from the bottom up through certain problems, the number of starting elbows and the elbows of the network connection of the first run handrail are preinstalled first, and then the straight handrails are bent up and down, and then the analysis can be performed.

Wrought iron stair installation Step 4:

Fixed assets are installed on wooden handrails and railings (railings), which are fixed with wood screws for tightening time, and the fixed horizontal spacing can be controlled within 400㎜. Operation should be at the fixed point, first drill a handrail material, and then screw the wood screw into, not hammer products into, whether the nut is flat. The handrail material is mainly fixed by inserting different supporting flat steel parts into the handrail trough, and the bending point and the straight line have no heating and pressing adhesion, and the latex can also be used to bond with the straight line section of the handrail.

Iron staircase installation Step five:

If the escalator is decorated with uneven curves, such as a fine wood file, it can be polished, and then the corner line becomes fresh, and the slope foot is very suitable.

Iron staircase installation Step six:

Finally, paint is painted, but the paint can be determined according to the design requirements and standards of the decoration needs, so that the paint can be painted.